--- comments: - comment: Still the same bug. Ringer volume always going back to its loudest position when doing a power reboot ? It would be nice to have a setting for this in the admin tool, but Grandstream doesn\'t care:( created: 2006-06-08 16:32:00 name: Tony B - comment: Loaded 1.0.8.23, will test created: 2006-06-08 22:21:35 name: stevehuggons@ntlworld.com - comment: "Software Version: Program-- 1.0.7.11 Bootloader-- 1.0.8.11 HTML-- 1.0.7.11 VOC-- 1.0.0.10" created: 2006-06-09 08:51:04 name: jimi@darth.dk - comment: Attended transfer lockup the BT102. No dial tone, no audio on received calls, no menu navigation on keypad and no web admin after a successful attended transfer. Same bug on 1.0.8.16. Anyone can test and confirm this ? Just tested on 2 devices. created: 2006-06-09 17:58:16 name: Leonardo Gomes - comment: Short CLID issue still not resolved. created: 2006-06-09 19:00:24 name: stevehuggons@ntlworld.com - comment: Short CLID issue still not resolved. created: 2006-06-09 19:00:34 name: stevehuggons@ntlworld.com - comment: HT486 REV 2.0 Program-- 1.0.8.23 Bootloader-- 1.0.8.11 HTML-- 1.0.8.23 VOC-- 1.0.0.10 created: 2006-06-09 19:49:29 name: alexander - comment: Seems to be working fine, so far created: 2006-06-13 23:52:46 name: alexander - comment: Unit registers with FWD and makes calls. But, any incoming call causes it to lose its internet connection (PPPoE, no NAT). LAN port still allows control pages access, but that it all. Reboot to fix. Ideas? created: 2006-06-15 18:14:09 name: rs0606@huskydog.org.uk - comment: REV 2.0 or HT487, Updated through http. Noticed no problems. created: 2006-06-16 17:28:49 name: Uncensored@me.net - comment: Noticed that occasionally incoming calls are lost immediately after establishing the connection. Will revert to previous firmware and see if the problem remains. created: 2006-06-18 14:19:40 name: alexander - comment: UDP port forwarding doesn\'t work for me. With 1.0.8.16 it was fine. Any ideas? created: 2006-06-18 20:50:53 name: roland_laxenburg@yahoo.co - comment: 1.0.8.23 no longer beta, now official created: 2006-06-19 18:56:15 name: stevehuggons@ntlworld.com - comment: I can no longer see the number of the person who is calling me. (I use a B&O telephone). I have set the Caller ID scheme to \"DTMF-Denmark\" like I did in the old version, but this seemes to have no effect. created: 2006-06-20 20:12:08 name: fwh@fwh.dk - comment: I also noticed that I have much more lost packets in this version of the firmware. I\'ll skip this release for sure. created: 2006-06-21 20:09:17 name: alexander - comment: Anyone able to use ringtone generator with 1.0.8.23 ? All sound corrupted when uploaded here. created: 2006-06-30 16:50:17 name: Andy - comment: It\'s not working created: 2006-07-06 22:27:28 name: zzf - comment: It\'s no incoming voice, can it downgrade to the earlier version? created: 2006-07-06 22:29:52 name: new user - comment: This version works ok on my side since it\'s not a beta one anymore. Since my internet upload is ~100kbps, I had troubles in the past w/ G711. Now ok with G729 (G723.1 was poor quality). I also have a timer that reset each night the ATA and the Cablem created: 2006-07-18 12:04:59 name: Arnaud - comment: 1.0.8.29 now available created: 2006-07-24 19:56:34 name: stevehuggons@ntlworld.com - comment: test created: 2007-10-31 10:58:04 name: Soren - comment: "Testing again ... " created: 2007-10-31 10:59:33 name: Soren - comment: Bla bla ? created: 2007-10-31 10:59:49 name: Soren - comment: one more test? created: 2007-10-31 11:01:46 name: Soren - comment: asdfasdfassfd created: 2007-10-31 12:03:55 name: asdfasdf note: One full A4 page of changes :-) phone: BT100_HT286_HT486 uploaded: 2006-06-08 13:31:15 uploader: sorend@rediffmail.com version: 1.0.8.23